
Taken from the Hawke website

Taken from the Hawke website
From time to time your target bosses will be in need of repairs. We know this as we go through the process of inspecting and repairing our targets at the club. Sometimes this is a complete rebuild, other times the boss straps or banding simply needs tightening up. In the next few articles I will be providing some thoughts and advice on how I go about repairing targets.
Bit of a disclaimer here. I am no expert but I have used these techniques and found them to work, but please take care and use common sense.
The only issue that can occur is if there isn’t enough banding to connect to the banding ratchet. To overcome this problem we came up with a quick solution of creating an extension strap. I can’t lay claim to coming up with this idea or technique entirely on my own and would like to thank Tony Parsons for his help and advice.

Buckle and extension strap
This is a length of about 12-14 inches with a buckle on the end. With a little luck there should be enough banding on the boss end to loop through the other side of the buckle.
You might want to use a pair of pliers to pull the end through as shown below.

You can then use the extended length of strapping in the bander to tighten the boss straps.


Be careful with using this technique as if there is insufficient banding on the buckle it can slip off.
Another added advantage of this method and the buckles is if you are careful you can tighten the bosses in situ on the course by just taking the banding ratchet and extension length.
Don’t over compress the bosses as we’ve found light poundage junior bows struggle to penetrate and arrows can bounce back.
Any comments or thoughts let me know.
I thought I’d share a tip or two on preparing target faces for competitions. We are in the process of pasting up a load of faces for a couple of competitions the club is running in a few weeks. Fortunately it’s been pretty warm so they have been drying real fast.
Like many other clubs we glue the target faces onto corrugated cardboard so they last longer on the day, usually using some form of PVA glue. One thing we’ve learnt is the centre of the target or the highest scoring zone gets shot out quite quickly. To try and make the faces last longer we paste an extra layer of cardboard behind the centre to help it keep it’s strength.
It seems to work and helps the faces last a little longer on the day. I’ve known other clubs to paste a layer of fabric on the back to do much the same thing.
We also paint a layer of PVA over the top of the face to help waterproof it. The only problem with doing this we’ve encountered is if you get the mix of PVA to water wrong, you can end up with a slight white sheen over the faces. So it is a bit of trial and error I’m afraid as different PVA seems to prefer different mix.
Hope this helps and thanks for reading.