Broken nock

Arrow making and repair tip on removing broken nock

I’ve been doing some repairs on some club Mybo Cadet arrows and I’d like to share this tip with you. Following a coaching session we had quite a few broken nocks.

Broken nock

Broken nock

When a nock breaks leaving a section in the shaft, it can be hard to remove. I found taking a small screw and carefully screwing it into the broken part of the nock can help. You can then use a pair of pliers to grip the screw and with a bit of puling it should come lose with the broken part of the nock attached.

broken nock removed

broken nock removed

It might take a couple of attempts but be patient, it should work.
Thanks for reading.

Arrow making tips and advice

 

Okay so as many of you know I make a lot of arrows and if truith be known I quite like it. I find the process of making them relaxing a lot of the time. The thing is I tend to make wooden arrows and not many with aluminium or carbon shafts these days since Sharon swapped back from shooting barebow to shooting woods.

Well I’ve been making up some club training arrows in readiness for some new courses we are running in January. They are Mybow Cadets from Merlin Archery and I’ll be posting a review of the arrows in a few months, but in the meantime I thought I’d share this tip. It was one given to me by Steve a fellow Briar Rose club member who is very experienced in shooting barebow and making up such arrows.

When making them I noticed the nock tends to rotate in the shaft, making it a bit tricky at times when mounting them on the fletching jig. Now you could add a drop of glue to secure them, but Steve suggested using cling film. Yes, the stuff that normally covers your supermarket produce.

If you wrap the end of the nock that fits into the shaft with a little film and then insert the nock it provides a tighter fit whilst still allowing some movement for alignment purposes.

The amount required varies but with a little trial and error I found a length of 5 to 6 cm and about 12 mm wide worked best. Wrapped tightly round the end that fits in the shaft and it seems to work pretty well.

Well I hope this helps, let me know how it works for you or if you have any other advice or such fixes. My thanks to Steve for the tip.

Thanks for reading.